Not Go Gauge for E27 Caps on Finished Lamps
2月 13, 2012
Go Gauge for Dimension “S1” of E27 Caps on Finished Lamps
6月 12, 2012

Go Gauge for lampholders of E27

E27 go gauge for lampholder

E27 go gauge for lampholder


Product Details:

Gauge Type: E27 Lampholders
Reference Standard: IEC60061-3
Model Number: 7006-25A-2

Detailed Description:

Purpose:

a)  The miniumum dimensions of the lampholder screw thread according to sheets 7004-21 and 7004-27.b)  Dimension X according to sheet 7005-20c) The mechanical compatibility of the lampholder with respect to lamos having adverse dimensions.

Testing:

a)  It shall be possible to screw the threaded part of the gauge into the lampholder without using undue force .b)  When the gauge has been screwed in as far as it will go , mark Y on the plunger shall be co-planar with mark A on the shaft.c)  The sleeve is then placed over the shaft of the gauge with its open end resting on the top edge of the screw shell of the holder .With the sleeve in this position,the plunger is pushed down as far as it will go.d)  Surface B of the gauge shall then lie between the marks X1 and X2 on the plunger or be co-planar with either of them ; it shall not lie beyond them.